Lay Goff Staking Plan
The Lay Goff Staking Plan is a recovery based staking plan.
The idea is to get back all losses over a period of time by following a loss with a stake sufficient to cover that loss plus the initial stake multiplied by 2.
The settings available in TSM are
Using the settings above of a start bank of £200 a percent to bet of 5% the initial stake is £10.
If the first bet was to lose at say odds of 5.3 we would lose £43. The next bet would be therefore be the amount lost + initial stake x 2 = £63.
If this results in a win then we are now £20 in front. We are trying to win £10 profit per bet. If however the second bet were to lose at odds of 5.3 we would lose £270.90.
We would now have to recover 2 losing bets, one of £43+£20 and one of £270.90+£20.
Instead of attempting to recover the losses in one go we attempt to recover them ONE AT A TIME. Our next bet is to recover the first loss of £43+£20. So the next stake is £63. If we are successful then our next bet is to recover the £270.90+£20.
Ultimately we end up with a list of losses that need to be recovered, which will be recovered sooner or later depending on how the results fall, and sometimes we will be free of losses to clear at which point we revert to our normal £10 stakes.
After, say 500 bets we should have a profit of £5000, less (if) any pending losses as yet unrecovered.
Larger sums that need recovering can be split. For instance if you did not want to stake more than £50 you would set your Split Loss Limit at £50. Any loss over this loss is then split up as per your settings. In the settings below any loss over £50 is split into 2 bets.
Our sister software – The Bet Machine – TBM was released in 2020. Every Back/Lay Staking Plan in TSM is available to use in The Bet Machine.
Used in conjunction with Gruss Betting Assistant, TBM is compatible with both Betfair and Betdaq Betting Exchange.
TBM incorporates Race Card data for UK/IRE Horse Racing and UK Greyhound Racing.
Create your own Horse and Greyhound Selection Systems in TBM by using the built in System Builder tool – Selection Hunter. Back Test your designed systems and find your edge.